0,00
(toimituskulut: 0,00)
Fischer 040771, Metalli, Grå, 11,1 cm, 8 mm, 10,6 cm, 50 kpl
Tuotenumero: [3521998] | Valmistaja: Fischer | Mallinum: 40771 | EAN: 4006209407714 | VVS-nr.: 516745140 | EL-nr.: 2774408111
Etävarastossa
Tuotetta on etävarastossamme. Toimitusaika noin 3-4 työpäivää.
Ilmainen toimitus Budbee - Box - Valitse itse mikä laatikko
Toimituskulut on laskettu vastaanottajan postinumeron perusteella: - Vaihda postinumero
Syötä postinumero toimitusta varten:
Katso kuljetusvaihtoehdot
| Budbee Laatikko - Nouda valitsemastasi laatikosta! | Gratis |
| Bring - Toimitus huoltopisteeseen | Gratis |
| Bring - Kotiinkuljetus -arkisin. | 20,08 |
EUR
190,21
ilman ALV 151,56
Kokonaishinta sis. toimitus
190,21
Tämä toiminto vaatii sisäänkirjautumisen. Luo käyttäjä ja voit käyttää listojamme esim. säännöllisiä ostoksia ja toivelistoja varten
Luo käyttäjä
Kirjaudu
Luo käyttäjä
Kirjaudu
Send på mail
The fischer bolt anchor FBN II is a steel anchor for cost-effective fixings in non-cracked concrete. Due to the long thread and the two anchorage depths, the fischer bolt anchor FBN II can be used in a particularly flexible manner. The bolt anchor is also suitable for stand-off installation as well as pre-positioned and in push-through installation. The zinc-plated steel version of the bolt anchor is suitable for fixing railings, cable trays, and consoles in internal areas.
Top Features
- The FBN II achieves maximum load-bearing capacity with standard anchorage depth. This means: fewer fixing points and smaller anchor plates.
- If the reduced anchorage depth is used, then this lowers the drill hole depth and simplifies installation.
- Component tolerances are balanced out with the long thread. In addition, FBN II is also suitable for stand-off installations. This increases flexibility.
- Simple assembly due to few taps and minimal slippage.
- The drive-in pin protects the thread from damage. This saves time during installation and removal.
Top Features
- The FBN II achieves maximum load-bearing capacity with standard anchorage depth. This means: fewer fixing points and smaller anchor plates.
- If the reduced anchorage depth is used, then this lowers the drill hole depth and simplifies installation.
- Component tolerances are balanced out with the long thread. In addition, FBN II is also suitable for stand-off installations. This increases flexibility.
- Simple assembly due to few taps and minimal slippage.
- The drive-in pin protects the thread from damage. This saves time during installation and removal.